ZCU102 Production Kit

Configuration

– Onboard JTAG configuration circuitry to enable configuration over USB
– Dual Quad-SPI flash memory
– Boot from SD card

Memory

– PS 4GB DDR4 64-bit SODIMM w/ ECC
– PL 512MB DDR4 component memory ([256 Mb x 16] devices) at 1200MHz / 2400Mbps DDR
– 8KB IIC EEPROM
– Dual 64MB Quad SPI flash
– SD card slot

Control & I/O

– 6x Directional Push Buttons (5x PL, 1x PS)
– DIP switches (8x PL)
– PMBUS & System Controller MSP430 for power, clocks, and I2C bus switching
– USB2/3

Expansion Connectors

– 2x FMC-HPC connectors
– 2x PMOD headers
– IIC

Communication & Networking

– RGMII communications at 10, 100, or 1000 Mb/s. Serial GMII interface supports a 1 Gb/s SGMII interface
– 4x SFP+ cage
– SMA GTH support (4x SMA Tx/Rx connectors)
– UART To USB bridge
– RJ45 Ethernet connector
– SATA (1 x GTR)**
– PCIe Gen2x4 Root Port**

Display

– HDMI video input and output (3 GTH)
– External Retimer device driving an HDMI output connector
– 9x GPIO user LEDs (8x PL, 1x PS)
–  VESA DisplayPort 1.2 source-only controller supports up to two lanes of main link data at rates of 1.62 Gb/s, 2.70 Gb/s, or 5.40 Gb/s.

Clocking

– Programmable clocks
– System clocks, user clocks, jitter attenuated clocks
– 2x SMA MGT input clocks

Power

– 12V wall adapter or ATX

 Data Sheet:

  https://docs.xilinx.com/v/u/en-US/ug1182-zcu102-eval-bd